top of page
Installation scheme
IMPORTANT REMARK!
A direct, permanent connection between the drinking water network and another system (such as a central heating system, rainwater tank, or swimming pool) is never permitted without approved protection.
Always comply with local legislation regarding this.
IMPORTANT: The message 'Low level detected' will only appear after a first filling after which the level has not been reached.
Simply holding the detector out of the water will not generate a low level message.
IMPORTANT TO KNOW:
When a command is given to 'force fill during 30 min' for example, the valve will only activate when the POOL LEVEL module synchronizes with the server (each 2 to 3 minutes). So it can take up to 3 minutes befores it activates, this is normal (don't expect instant action)
Installation via the Bluematic app:
Go to 'Settings' - 'My equipment' - 'Add an equipment' and choose
'My Water Level Regulator' click on the LRLEVEL-xxxx that appears and follow the procedure on the screen
The system will ask you if you have a wireless levelsensor.
Clikck YES if you have a wireless sensor
Click NO if you have a wired sensor
Next fill in the pool filling speed (12l/m, 30l/m or other) and
maximum permitted daily fill (in m³)
The system will now ask you to install the wireless water levelsensor.
Click on the POOL_LVL-xxx that appears and follow the procedure
IMPORTANT MESSAGE CONCERNING LEAK ALARM
Sometimes an alarm may be sent indicating that a leak has been detected. This alarm occurs when the turbine runs outside of a filling period. This could possibly indicate a leak in the solenoid valve.
However, if no check valve has been installed to the water supply, negative pressure from the water line can cause the turbine to start rotating in the opposite direction. This can therefore generate a flax alarm.
How to charge the wireless detector?
Open the round cap on the back by rotating counterclockwise als charge via the USB-C contact. Close afterwards and place in the pool again.Will connect automatically.
.png)
bottom of page