top of page
Blue+ InverSilence
Blue+ HQ
Blue+ InverSmart
Blue+ I-Flow
Info I-Flow
Important note regarding the Blue+ I-Flow pump!
This pump does not use a fifth wire with a stop function.
When the common is interrupted, it returns to its last
manual setting. If the last setting was 'STOP', the pump will stop.
For example, if the last manual setting was 80%, it will go to 80%.
Therefore, it's best to connect the pump to the command wire
to Bluematic from a standstill.
For single speed pumps
2 possibilities:
-With contactor (see procedure underneath)
-Without contactor (form fuse -> phase over 'FC contact' + neutral -> to pump)
For non-Blue+ variable speed pump
bottom of page