top of page
Smart Energy setting on
% based on desired activation point of available
solar overproduction
Menu Filtration
* Mode = ON or AUTO
Menu Heat Pump
*Mode = AUTO
Activation setpoint = Not Used
Standby setpoint = 28°C for a physical heat pump temperature of 30°C (or according to your personal preference)
No time slot
RESULT:
If the water temperature drops below the Standby Setpoint, the Pool Command will trigger the heat pump output "autonomously"
The Smart Energy algorithm is "superimposed" on the "autonomous" mode of the Pool Command and will trigger the heat pump if the solar overproduction exceeds the parameterized power threshold
(check 'heatpump setting' for correct activation/consumption!)
bottom of page